There are 2 options to install the Transmitter (both options are included with all SadoTech doorbell kits:
Option 1 - Adhesive Tape
Steps:
- Tear off the paper on one side of the adhesive tape and apply to the rear cover of the outdoor unit.
- It is suggested to clean the wall or door in which the doorbell is to be installed so that the doorbell can have better adhesion.
- Tear off the other side of the adhesive tape on the outdoor unit.
- Install the outdoor unit on the wall and press on it for 30 seconds.
Option 2 - Anchors & Screws (preferred method)
Steps:
- Remove the battery and unscrew the screws on the circuit board.
- Make a hole by drilling into the hole markers on the cover of the outdoor unit with drill or pointed object until it is open. Use the hole markers you just made to mark the location of where you want it installed. With the marked holes install the supplied anchor bold, if needed.
- Now you are ready to install the supplied screw into the expansion anchor bolt on the rear cover of the outdoor unit in the direction as illustrated in the figure with a screwdriver into the anchor.
- Install the circuit board back on and place the cover back on the outdoor unit.